Military Shelters
Camp kit
Command Tent
Made from a strong ripstop polyester. Supplied with a Zinc plated steel frame complete with a ground bar to enable this tent to be erected on a hard standing. Complete with pegs & mallet in valise-ready to erect. One end of the tent is fitted with a sleeve / porch area which will fit over the rear of most 4x4 vehicles
Specification
- Floor space:2.94m x 2.63m (7.7m2)
- Wall height: 1.65m (5.4')
- Center height: 2.m (6')
C-series Shelters
The Deployable Rapid Assembly Shelter (DRASH) C Series is a lightweight, man-portable, rugged, reliable and user-friendly soft-walled shelter solution to establishing mobile command and control, life support, signal node or reconnaissance shelter anywhere in the world.
Applied as a stand alone shelter or easily connectable to other shelters, the shelter’s three part components, comprising of the shelter frame with pre-attached covers, ground cover and floor, can be set up within minutes of arriving at location, without using special tools or dealing with loose parts.
S-series Shelters
S Series Shelters have an interior width of 3.5 metres (11.5 ft), and come in six model sizes in three basic variants, providing from 10.4 - 37.7 square metres (112 – 402 sq. ft.) of usable space depending on the model and the variant.
The S Variant can be used as a stand alone shelter or easily connected to other DRASH shelters using a Connector Set. The Truncated or ST Variant can connect at one end to another T variant for extended lengths. The SI Variant is comprised of a midsection that can be connected on both ends for extended lengths. S Series Shelters increase in length by increments of approximately 1.5 metres (5 ft) starting at a length of 4.1 metres (13.5 ft) with a maximum length measuring up to 11.7 metres (38.5 ft) long. The interior height is 2.5 metres (8.25 ft).
XB-series Shelters
XB Series Shelters have an interior width of 4.2 metres (13.6 ft.), and come in six model sizes in three basic variants, providing from 13 to 38.4 square metres (140.4 to 413.4 sq.ft.) of usable space depending on the model and the variant.
The XB Variant can be used as a stand alone shelter or easily connected to other DRASH shelters using a Connector Set. The Truncated or XBT Variant can connect at one end to another T Variant to create extended lengths. The XBI Variant is comprised of a midsection that can be connected on both ends to create extended lengths.
XB Series Shelters increase in length by increments of approximately 1.2 metres (4 ft.) starting at a length of 4.7 metres (15.3 ft.) with a maximum length measuring up to 10.8 metres (35.3 ft.). The interior height is 2.7 metres (8.8 ft.).
